LogSweep and Mic Alignment Error

[AustinH]

Hi, I'm trying to make some measurements, but I'm getting an error when I use the logsweep and mic alignment function.

logsweep error.png (115.51 KiB) Viewed 844 times

mic alignment error.png (99.94 KiB) Viewed 844 times

I was able to use LSR3 just fine with the default settings. How do I fix this error in Acourate?

LSR3.png (99.67 KiB) Viewed 844 times

Also, I purchased a Focusrite Scarlette 2i2 + Dayton EMM-6 as I've read in other posts about the UMIK-1 being finicky. It's being shipped, so that'll have to wait. However, it's bizarre that LSR3 was able to complete the mic alignment and sweep properly. Is there a way to import the results from LSR3 over?

[UliBru]

1. My fault. By mistake I must have deleted today an important link in the internal playback chain.
Please download the setup once again and install it over the existing installation.

2. You can use the resulting pulses from LSR3 recording

3. The picture of the recorded pulses seem to show up two pulses with opposite polarity. Please check.