Acourate User Group

Posted: **11 Dec 2021 19:15**

Hi, I'm trying to make some measurements, but I'm getting an error when I use the logsweep and mic alignment function.

: logsweep error.png (115.51 KiB) Viewed 846 times

: mic alignment error.png (99.94 KiB) Viewed 846 times

I was able to use LSR3 just fine with the default settings. How do I fix this error in Acourate?

: LSR3.png (99.67 KiB) Viewed 846 times

Also, I purchased a Focusrite Scarlette 2i2 + Dayton EMM-6 as I've read in other posts about the UMIK-1 being finicky. It's being shipped, so that'll have to wait. However, it's bizarre that LSR3 was able to complete the mic alignment and sweep properly. Is there a way to import the results from LSR3 over?

Posted: **11 Dec 2021 20:23**

1. My fault. By mistake I must have deleted today an important link in the internal playback chain.
Please download the setup once again and install it over the existing installation.

2. You can use the resulting pulses from LSR3 recording

3. The picture of the recorded pulses seem to show up two pulses with opposite polarity. Please check.

Acourate User Group

LogSweep and Mic Alignment Error

LogSweep and Mic Alignment Error

Re: LogSweep and Mic Alignment Error